D89 Engine Seal Grey Gasket Maker

·Good resistance to oil and joint movement

·Can be supplied in cartridges, tubes or rocep cans

·For use with flexible flanges

·Reduces migration of liquid after application

·Automobile:Transmission case halves, valve covers, center and end covers (transmissions), crank case halves, cam covers, timing chain cases, primary drives, side covers, and clutch housings.

·Motorcycle:Case halves, carburetor gaskets

·Make sure that surfaces to be sealed are clean and oil free.

·Apply a continuous bead of sealants to both surfaces of parts to be sealed.

·Smooth material with small brush.

·Wait about one minute then mate parts together.

·Bolt parts using normal torque specifications.

Products shall be ideally stored in a cool, dry location in unopened containers at a temperature between 8 to 28C (46 to 82F) unless otherwise labeled. Optimal storage is at the lower half of this temperature range. To prevent contamination of unused product, do not return any material to its original container.